Digitus DIGITUS Plug&View OptiView Manual de usuario descargar pdf (Pagina 13)

Plug&View IP camera ׀ Manual ׀ ML-201310 13

Send E-Mail will send an e-mail to the “send to addresses” which are configured under e-mail setup.

“Alarm with Snapshot” will send a snaphot via e-mail or FTP. “Alarm with record” will upload the

records via FTP. Trigger alarm output* will trigger the alarm output (digital output).

With the schedule you can configure the time schedule for the motion detection. You can set up a

week mode, work mode or with all times day a continuos recording. Please save your configuration by

clicking “Apply”.

*Camera must have digital In and Output (Alarm In/Out)

5.3.10 Alarm In Out

If your camera has “Alarm In and Out”, you can configure the settings here. You can use a sensor

to trigger the alarm in. Please configure, if the used device will trigger the input with a high or a low

signal.

Actions are similar to the motion detection actions. For setting up, please refer to motion detection.

Alarm out will trigger a relay. Please configure, if the alarm out will be open or grounded. Please

configure also the dwell time of the signal.

5.3.11 Snapshot

In Snapshot you can configure to take a snapshot in a specified interval. Please enable the status and

configure the interval the snapshot should be taken. Choose as action if the snapshot should be send

by e-mail or upload via FTP.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Digitus DIGITUS Plug&View OptiView Manual de usuario Pagina 13